Over het archief
Het OWA, het open archief van het Waterbouwkundig Laboratorium heeft tot doel alle vrij toegankelijke onderzoeksresultaten van dit instituut in digitale vorm aan te bieden. Op die manier wil het de zichtbaarheid, verspreiding en gebruik van deze onderzoeksresultaten, alsook de wetenschappelijke communicatie maximaal bevorderen.
Dit archief wordt uitgebouwd en beheerd volgens de principes van de Open Access Movement, en het daaruit ontstane Open Archives Initiative.
Basisinformatie over ‘Open Access to scholarly information'.
| one publication added to basket [296069] |
Different proxies for the reactivity of aquatic sediments towards oxygen: a model assessment
Van Frausum, J.; Middelburg, J.J.; Soetaert, K.; Meysman, F.J.R. (2010). Different proxies for the reactivity of aquatic sediments towards oxygen: a model assessment. Ecol. Model. 221(17): 2054-2067. https://dx.doi.org/10.1016/j.ecolmodel.2010.06.001
In: Ecological Modelling. Elsevier: Amsterdam; Lausanne; New York; Oxford; Shannon; Tokyo. ISSN 0304-3800; e-ISSN 1872-7026, meer
|  |
| Trefwoord |
|
| Author keywords |
Modelling; Sediment biogeochemistry; O-2 penetration; O-2 uptake; O-2consumption rates |
| Auteurs | | Top |
- Van Frausum, J., meer
- Middelburg, J.J., meer
- Soetaert, K., meer
- Meysman, F.J.R., meer
|
|
|
| Abstract |
Information on benthic carbon mineralization rates is often derived from the analysis of oxygen micro-profiles in sediments. To enable a direct comparison of different sediment environments, it is often desirable to characterize sediments by a single proxy that expresses their "reactivity" towards oxygen. For this, there are three commonly used proxies: the oxygen penetration depth (OPD), the oxygen flux at the sediment-water interface (DOU), and the maximum volumetric oxygen consumption rate (R-max). The OPD can be directly determined from the oxygen depth profile, while the DOU is usually obtained by a linear fit to the oxygen gradient either in diffusive boundary layer. The oxygen consumption rate R-max requires the fitting of a reactive-transport model to the data profile. This article shows that the OPD alone is a suboptimal proxy, because it shows a strong dependence on the half-saturation constant K-s, and secondly, because it is sensitive to the particular re-oxidation conditions right above the oxic-anoxic interface. Similarly, the volumetric oxygen consumption rate R-max is rather strongly dependent on the kinetic model formulation employed. To show this we fitted three different (Bouldin, Blackman and Monod) kinetics to the same oxygen data profiles. When fitting these models, the R-max values obtained differed by 20% for exactly the same oxygen profile. Accordingly, if one reports R-max values, it is crucial to specify the kinetic model alongside. Overall, DOU emerges as sediment reactivity proxy which is the least model dependent. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.
