Over het archief
Het OWA, het open archief van het Waterbouwkundig Laboratorium heeft tot doel alle vrij toegankelijke onderzoeksresultaten van dit instituut in digitale vorm aan te bieden. Op die manier wil het de zichtbaarheid, verspreiding en gebruik van deze onderzoeksresultaten, alsook de wetenschappelijke communicatie maximaal bevorderen.
Dit archief wordt uitgebouwd en beheerd volgens de principes van de Open Access Movement, en het daaruit ontstane Open Archives Initiative.
Basisinformatie over ‘Open Access to scholarly information'.
| [ meld een fout in dit record ] | mandje (1): toevoegen | toon |
 |
| one publication added to basket [205886] | |
| Influence of the length of an estuary on tidal motion and sediment trapping Schuttelaars, H.M.; De Jonge, V.N.; Chernetsky, A. (2011). Influence of the length of an estuary on tidal motion and sediment trapping. Delft University of Technology: Delft. 29 pp.
|
| Beschikbaar in | Auteurs |
| |
| Auteurs | Top | |
| Abstract |
If the length of the estuary would be increased to 90 km, using parameter values representative for the Ems estuary in 2005, the model results suggest that • the character of the tidal wave changes from a standing wave into a travelling wave. • the lowest low water level will increase with approximately 60 cm and the highest water level will decrease with 70 cm, 60 km from Knock. • the ebb velocity will increase to approximately 1 ms−1, while the flood velocity will not change significantly ( 95 cm s−1). • changes in tidal asymmetry can not be inferred from changes in the sea surface elevations, but can only be deduced from an analysis of the velocity components. • an increase of the length of the estuary by approximately 10 km would result in accumulation of fine sediment near Emden, instead of close to the weir. We would like to stress that the results of idealised models, state–of–the–art numerical models and observations should be used in an integrated way. The power of state–of–the–art numerical models is that, after calibrating the model to observations, very detailed calculations of water motion and sediment dynamics under those system conditions can be carried out. However, parameter sensitivity studies are difficult to perform both due to limitations of computational time and the absence of observations for those conditions, necessary to calibrate the model. The power of idealised analytical models is that they are specifically developed to describe the changes in general patterns under varying system boundary conditions and parameter settings. This means that the predicted effects by idealised model(s) need to be carefully tested by state–of–the–art numerical models, and numerical models should qualitatively show the behaviour suggested by the idealised model. Therefore, under the given situation with respect to models, a combination of both types of models will lead to a clear synergy and the best possible results. |
| Top | Auteurs |
