Archief Prof. Ir. J.J. Peters

Over het archief

In 2012 verloren we Jean Jacques Peters, voormalig ingenieur van het Waterbouwkundig Laboratorium (1964 tot 1979) en internationaal expert in sedimenttransport, rivierhydraulica en -morfologie. Als eerbetoon aan hem hebben we potamology (http://www.potamology.com/) gecreëerd, een virtueel gedenkarchief dat als doel heeft om zijn manier van denken en morfologische aanpak van rivierproblemen in de wereld in stand te houden en te verspreiden.

Het merendeel van z’n werk hebben we toegankelijk gemaakt via onderstaande zoekinterface.

[ meld een fout in dit record ]

mandje (0): toevoegen | toon

---

Modelling culverts in TELEMAC: code validation with scale flume model of Doelpolder Smolders, S.; Vercruysse, J.B.; Spiesschaert, T.; Geerts, S.; Mostaert, F. (2019). Modelling culverts in TELEMAC: code validation with scale flume model of Doelpolder. Version 3.0. FHR reports, 18_145_1. Flanders Hydraulics Research: Antwerp. VII, 30 pp. Deel van: FHR reports. Flanders Hydraulics Research: Antwerp

---

Beschikbaar in	Auteurs
Waterbouwkundig Laboratorium: Open Repository 323366 [ OWA ] Waterbouwkundig Laboratorium: WL Rapporten [323339]
Documenttype: Projectrapport

---

Trefwoorden

Culverts Hydraulics and sediment > Climate change > Controlled Reduced Tide (CRT) area Numerical modelling Physical modelling Physical models

Author keywords

Controlled reduced tide

---

Project	Top | Auteurs
Culverts in TELEMAC - code validation

---

Auteurs		Top
Smolders, S. Vercruysse, J.B. Spiesschaert, T.	Geerts, S. Mostaert, F.

---

Abstract

A scale model of part of the inlet culvert construction of Doelpolder was available after project 15_073 (Scale model test on combined in- and outflow construction of Doelpolder). Additional flume tests were done with this scale model in four different setups: without weir logs and without a trash screen, with weir logs and without a trash screen, without weir logs and with a trash screen, and with weir logs and with a trash screen. For eight different sets of fixed water levels before and after the culverts the discharge for each setup was measured. These measured discharges are then compared with calculated discharge, based on the same water levels and construction parameters with a set of discharge through a culvert formulations built in the code of TELEMAC. The calculated discharge are in good agreement with the measured ones. This shows that the culvert formulas present in TELEMAC are capable of reproducing the discharges through the complex culvert structures of the Flemish flood control areas.

---

Alle informatie in het Integrated Marine Information System (IMIS) valt onder het VLIZ Privacy beleid

Top | Auteurs

IMIS is ontwikkeld en wordt gehost door het VLIZ.