Zoeken
Zoeken kan via de modus 'eenvoudig zoeken' (één veld) of uitgebreid via 'geavanceerd zoeken' (meerdere velden). Zo kan je bv. zoeken op een combinatie van een auteursnaam (auteur), een jaartal (jaar) en een documenttype.
Boekenmand
Nuttige resultaten kan je aanvinken en toevoegen aan een mandje. De inhoud hiervan kan je exporteren of afdrukken (naar bv. PDF).
RSS
Op de hoogte blijven van nieuw toegevoegde publicaties binnen uw interessegebied? Dit kan door een RSS-feed (?) te maken van jouw zoekopdracht.
| [ meld een fout in dit record ] | mandje (0): toevoegen | toon |
 |
| Investigation into the non‐linear hydrodynamical processes in the Scheldt River: idealised processes study Dijkstra, Y.M. (2022). Investigation into the non‐linear hydrodynamical processes in the Scheldt River: idealised processes study. Version 4.0. FHR reports, 15_039_1. Flanders Hydraulics Research: Antwerp. VII, 25 + 9 p. app. pp.
Deel van: FHR reports. Flanders Hydraulics Research: Antwerp, meer
|
| Beschikbaar in | Auteur |
| |
| Documenttype: Projectrapport | |
| Trefwoorden |
Hydraulics and sediment > Hydrodynamics > Turbulence Hydraulics and sediment > Hydrodynamics > Water levels Numerical modelling België, Schelde R. [Marine Regions] |
| Author keywords |
|
| Project | Top | Auteur |
|
| Auteur | Top | |
|
| Abstract |
The k − ε turbulence closure model was used to derive linear and non‐linear parametrisations of turbulence that depend only on one calibration parameter. The calibration yields a clear best fit for the M2 tide, while no single best value for the M4 tide could be found. The result of the calibration on the M2 tide yields a good description of this tidal component, though the amplitude is overestimated in the Upper Sea Scheldt when using the linear model. The M4 tidal amplitude is typically overestimated by the model in the whole estuary. The relative phase of both the M2 and M4 tidal components are well described. The higher‐order non‐linear mechanisms are insignificant for the Western Scheldt and Lower Sea Scheldt, but are important in the Upper Sea Scheldt. The model shows a further set‐up of the M2 tide in the Upper Sea Scheldt as a consequence of these mechanisms. This set‐up increases the discrepancy between modelled and measured water levels. Damping of the M2 tide is achieved by including a non‐linear description of turbulent mixing. This description relates turbulent mixing to the local velocity magnitude. The relatively high tidal velocity in the Upper Sea Scheldt then produces additional mixing and therefore damping of the tide. An additional source of damping is found by including time variations of turbulent mixing on the tidal time‐scale. This also improves the correspondence between the modelled and measured M4 tide. Nevertheless, the error in the modelled M4 tidal amplitude remains large, with values up to 100%. The total effect of all non‐linear terms and turbulent mixing improve the result compared to that of Brouwer et al. (2017), but do nevertheless not produce a sufficient degree of damping of the tide in the Upper Sea Scheldt. It is therefore concluded that a change in the roughness value or the representative depth of the system is required to further improve the model result. The additional physical mechanisms studied in this report do not lead to a qualitative change in measures of tidal asymmetry. Although these measures provide an indication for the direction of the net sediment transport, the effect of non‐linear terms on the net sediment transport remains to be investigated. |
| Top | Auteur |
