Zoeken
Zoeken kan via de modus 'eenvoudig zoeken' (één veld) of uitgebreid via 'geavanceerd zoeken' (meerdere velden). Zo kan je bv. zoeken op een combinatie van een auteursnaam (auteur), een jaartal (jaar) en een documenttype.
Boekenmand
Nuttige resultaten kan je aanvinken en toevoegen aan een mandje. De inhoud hiervan kan je exporteren of afdrukken (naar bv. PDF).
RSS
Op de hoogte blijven van nieuw toegevoegde publicaties binnen uw interessegebied? Dit kan door een RSS-feed (?) te maken van jouw zoekopdracht.
nieuwe zoekopdracht
Different proxies for the reactivity of aquatic sediments towards oxygen: a model assessment
Van Frausum, J.; Middelburg, J.J.; Soetaert, K.; Meysman, F.J.R. (2010). Different proxies for the reactivity of aquatic sediments towards oxygen: a model assessment. Ecol. Model. 221(17): 2054-2067. https://dx.doi.org/10.1016/j.ecolmodel.2010.06.001
In: Ecological Modelling. Elsevier: Amsterdam; Lausanne; New York; Oxford; Shannon; Tokyo. ISSN 0304-3800; e-ISSN 1872-7026
| |
Trefwoord |
|
Author keywords |
Modelling; Sediment biogeochemistry; O-2 penetration; O-2 uptake; O-2consumption rates |
Auteurs | | Top |
- Van Frausum, J.
- Middelburg, J.J.
- Soetaert, K.
- Meysman, F.J.R.
|
|
|
Abstract |
Information on benthic carbon mineralization rates is often derived from the analysis of oxygen micro-profiles in sediments. To enable a direct comparison of different sediment environments, it is often desirable to characterize sediments by a single proxy that expresses their "reactivity" towards oxygen. For this, there are three commonly used proxies: the oxygen penetration depth (OPD), the oxygen flux at the sediment-water interface (DOU), and the maximum volumetric oxygen consumption rate (R-max). The OPD can be directly determined from the oxygen depth profile, while the DOU is usually obtained by a linear fit to the oxygen gradient either in diffusive boundary layer. The oxygen consumption rate R-max requires the fitting of a reactive-transport model to the data profile. This article shows that the OPD alone is a suboptimal proxy, because it shows a strong dependence on the half-saturation constant K-s, and secondly, because it is sensitive to the particular re-oxidation conditions right above the oxic-anoxic interface. Similarly, the volumetric oxygen consumption rate R-max is rather strongly dependent on the kinetic model formulation employed. To show this we fitted three different (Bouldin, Blackman and Monod) kinetics to the same oxygen data profiles. When fitting these models, the R-max values obtained differed by 20% for exactly the same oxygen profile. Accordingly, if one reports R-max values, it is crucial to specify the kinetic model alongside. Overall, DOU emerges as sediment reactivity proxy which is the least model dependent. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.