Zoeken
Zoeken kan via de modus 'eenvoudig zoeken' (één veld) of uitgebreid via 'geavanceerd zoeken' (meerdere velden). Zo kan je bv. zoeken op een combinatie van een auteursnaam (auteur), een jaartal (jaar) en een documenttype.
Boekenmand
Nuttige resultaten kan je aanvinken en toevoegen aan een mandje. De inhoud hiervan kan je exporteren of afdrukken (naar bv. PDF).
RSS
Op de hoogte blijven van nieuw toegevoegde publicaties binnen uw interessegebied? Dit kan door een RSS-feed (?) te maken van jouw zoekopdracht.
nieuwe zoekopdracht
Improving the calculation of evaporating sprays for medium-speed marine-engine-like conditions
Li, H.; Beji, T.; Verhelst, S. (2021). Improving the calculation of evaporating sprays for medium-speed marine-engine-like conditions. Atomization and Sprays 31(8): 55-79
In: Atomization and Sprays: Danbury. ISSN 1044-5110; e-ISSN 1936-2684
| |
Trefwoord |
|
Author keywords |
diesel spray; marine engine; turbulence effect; numerical simulation |
Auteurs | | Top |
- Li, H.
- Beji, T.
- Verhelst, S.
|
|
|
Abstract |
In order to reduce maritime transportation's greenhouse gas and pollutant emissions, marine engine manufacturers need to deepen the fundamental understanding of the injection and spray process. But little knowledge is openly available on marine engine fuel sprays, and their numerical simulation. In this paper, two-dimensional unsteady-state Reynolds-averaged Navier-Stokes simulations were performed to study evaporating high-pressure marine engine sprays, in which an injector with a nozzle diameter of 0.44 mm was used. The proposed approach was first validated using measurement data of Spray A and Spray D from the Engine Combustion Network. A satisfactory agreement with the Engine Combustion Network data demonstrated that the simulation can correctly capture the spray processes. However, a discrepancy was found when simulating the marine engine sprays. After summarizing and analyzing the values of the turbulence model constant (C1 of the standard k-ε model) used from the published literature, a lower value of C1 was adopted, and good agreement under a wide range of ambient conditions (density varying from 7.6 to 22.5 kg/m3, and temperature varying from 700 to 950 K) was achieved. Also, the disagreement that was noted for the liquid penetration for a low-temperature case could be explained by the ligament detachment phenomenon which was captured by the computational fluid dynamics simulation. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.